AXI4-Lite Interface Standard SPI Mode — Optional FIFOs in Legacy Mode - 3.2 English

PG153 AXI Quad SPI Product Guide

Document ID
Release Date
3.2 English

When the core is configured in standard SPI mode you have the flexibility of including optional FIFOs of either 16 or 256 deep in the design. Because the AXI Quad SPI is full-duplex, both transmit and receive FIFOs are instantiated as a pair and can be included in the core as shown in This Figure.

When FIFOs are implemented, the slave select address is required to be the same for all data buffered in the FIFOs. This is necessary because there is no FIFO for the slave select address. Both transmit and receive FIFOs are 16 (or 256) elements deep and are accessed using single AXI transactions because burst mode is not supported.

The transmit FIFO is write-only. When data is written into the FIFO, the occupancy number is incremented and when a SPI transfer is completed, the number is decremented. As a consequence of this operation, aborted SPI transfers still have the data available for the transmission retry. The transfers can only be aborted in the master mode by setting the master transaction inhibit bit, bit 8 of the SPICR, to 1 during a transfer. Setting this bit in the slave mode has no effect on the operation of the slave. These aborted transfers are on the SPI interface. The occupancy number is contained in a read-only register.

If a write is attempted when the FIFO is full, an acknowledgment is given along with a generated error signal. Interrupts associated with the transmit FIFO include:

Data transmit FIFO empty

Transmit FIFO half empty

Transmit FIFO under-run

See Interrupt Register Set Description for details.

The receive FIFO is read-only. When data is read from the FIFO, the occupancy number is decremented and when a SPI transfer is completed, the number is incremented. If a read is attempted when the FIFO is empty, acknowledgment is given along with a generated error signal. When the receive FIFO becomes full, the receive FIFO full interrupt is generated.

Data is automatically written to the FIFO from the SPI module shift register after the completion of a SPI transfer. If the receive FIFO is full and more data is received, a receive FIFO overflow interrupt is issued. When this occurs, all attempts to write data to the full receive FIFO by the SPI module are lost.

When the AXI Quad SPI core is configured with FIFOs, SPI transfers can be started in two different ways depending on when the enable bit in the SPICR is set. If the enable bit is set prior to the first data being loaded in the FIFO, the SPI transfer begins immediately after the write to the master transmit FIFO. If the FIFO is emptied using SPI transfers before additional elements are written to the transmit FIFO, an interrupt is asserted. When the AXI to SPI SCK frequency ratio is sufficiently small, this scenario is highly probable.

Alternatively, the FIFO can be loaded with up to 16 or 256 elements and then the enable bit can be set, which starts the SPI transfer. In this case, an interrupt is issued after all elements are transferred. In all cases, more data can be written to the transmit FIFOs to increase the number of elements transferred before emptying the FIFOs.