Architecture - 3.4 English

Versal Adaptive SoC CPM DMA and Bridge Mode for PCI Express Product Guide (PG347)

Document ID
Release Date
3.4 English

Internally, the subsystem can be configured to implement up to eight independent physical DMA engines (up to four H2C and four C2H). These DMA engines can be mapped to individual AXI4-Stream interfaces or a shared AXI4 memory mapped (MM) interface to the user application. On the AXI4 MM interface, the XDMA Subsystem generates requests and expected completions. The AXI4-Stream interface is data-only.

The type of channel configured determines the transactions on which bus:
  • A Host-to-Card (H2C) channel generates read requests to PCIe and provides the data or generates a write request to the user application.
  • A Card-to-Host (C2H) channel either waits for data on the user side or generates a read request on the user side and then generates a write request containing the data received to PCIe.

The XDMA also enables the host to access the user logic. Write requests that reach ‘PCIe to DMA bypass Base Address Register (BAR)’ are processed by the DMA. The data from the write request is forwarded to the user application through the NoC interface to the PL logic.

The host access to the configuration and status registers in the user logic is provided through an AXI master port. These requests are 32-bit reads or writes. The user application also has access to internal DMA configuration and status registers through an AXI slave port.

When multiple channels for H2C and C2H are enabled, transactions on the AXI4 Master interface are interleaved between all selected channels. Simple round robin protocol is used to service all channels. Transactions granularity depends on host Max Payload Size (MPS), page size, and other host settings.