Example 11: ULPS Operation at D-PHY RX (Slave) Data Lane - 4.3 English - PG202

MIPI D-PHY LogiCORE IP Product Guide (PG202)

Document ID
PG202
Release Date
2024-12-04
Version
4.3 English

The RX Data lane ULPS entry is indicated by assertion of rxulpsesc along with assertion of ulpsactivenot (active-Low) signal. ULPS exit is marked by reception of MARK-1 on the line and ulpsactivenot is deasserted. After receiving MARK-1 for T_WAKEUP time (1 ms minimum), rxulpsesc is deasserted. This behavior is shown in the following figure.

Figure 1. D-PHY RX (Slave) ULPS Mode Operation for Data Lane