- Connect the Tokyo Electron Device Limited (TED) TB-FMCH-DP3 module to the HPC FMC connector on the KC705 (or KCU105) board or to the HPC0 connector on the ZCU102 depending on your design.
- Connect a USB cable (Type A to mini B) from the host PC to the USB UART port on the KC705 for serial communication. In the case of KCU105 or ZCU102, use Type A to micro B type of USB cable.
- Connect a JTAG USB Platform cable or a USB Type A to Micro B cable from the host
PC to the board for programming bit and
elffiles. - For the pass-through or TX only applications, connect a DP cable from the TX port of the TED TB-FMCH-DP-3 module to a monitor, as shown in the following figures.
- For the pass-through or RX only applications, connect a DP cable from the RX port of the TED TB-FMCH-DP-3 module to a DP source (GPU), as shown in the following figures.