ZCU102 Evaluation Board Setup

Memory and Peripheral Protection Unit for PL Isolation in Zynq UltraScale+ Devices (XAPP1353)
Document ID
XAPP1353
Release Date
2022-05-04
Revision
1.1 English
  1. Connect a USB cable to the UART port of the board and identify the COM ports that were mapped to it.
  2. (Optional) Connect a USB cable to the JTAG port of the board to utilize the Debugger.
  3. Set up two (2) serial communication terminals to observe output on UART0 (APU) and UART1 (RPU).
    1. Baud rate: 115200
    2. Date bits: 8
    3. Parity: None
  4. Stop bits: 1
  5. Set boot mode:SD (see the following figure for reference)
    1. MODE[3:0]>1110>SW6-[4:1]>OFF-OFF-OFF-ON
      Figure 1. SW6 Boot Mode