This boot mode is supported onboard and is wired to XCVP1202 U1 bank 500 PMC_MIO[0:12] pins. The supported QSPI configuration is dual-parallel x8. To boot from QSPI, follow these steps.
- Store a valid XCVP1202 ACAP boot image file in the QSPI.
- Set boot mode SW1 for QSPI32 as indicated in the "Mode Switch SW1 Configuration Option Settings" table in Versal ACAP Configuration.
- Power-cycle the VPK120 board or press the POR pushbutton SW2. SW2 is near the mode pin dip switch in the figure in Board Component Location.