- Gen1 (2.5 GT/s), Gen2 (5.0 GT/s), Gen3 (8.0 GT/s), Gen4 (16.0 GT/s), and Gen5 (32.0 GT/s) speeds are supported.
-
Versal devices support:
- 2.5 GT/s, 5.0 GT/s, and 8.0 GT/s line rates with x1, x2, x4, x8, and x16
lane operation.Note: x16 lane width support is dependent on the available GTYP in the selected device/package.
- 16.0 GT/s line rate with x1, x2, x4, and x8 lane operation.
- 32.0 GT/s line rate with x1, x2, and x4 lane operation.
- 2.5 GT/s, 5.0 GT/s, and 8.0 GT/s line rates with x1, x2, x4, x8, and x16
lane operation.
- GT Quad is always outside the PHY IP and it is available in the IP integrator block design on opening the example design.
- Only GTYPs that are not dedicated to CPM5 are available for use for PL use cases. Refer to GT Selection and Pin Planning for Versal Premium for more information.
- Supports PIPE low power state of P0s only at Gen1 or Gen2 speeds. PIPE P0s are equivalent to MAC LTSSM state of L0s.
- Supports synchronous and asynchronous applications.
- Rate change between Gen1 and Gen2 is a fixed datapath implementation.
- Transceiver reset sequence is part of the GT Quad in Versal premium devices as compared to UltraScale and UltraScale+.
- There is no option to choose the GT Quad location in the PHY IP GUI. You are expected to LOC the suitable GT Quad in the top level constraints file (XDC).