Building Software - 2020.2 English

Zynq UltraScale+ MPSoC Software Developer Guide (UG1137)

Document ID
UG1137
Release Date
2021-01-05
Version
2020.2 English

All the software components are built and packaged by Xilinx PetaLinux tool. See PetaLinux wiki page for more information on how to build and package software components.

Build Flag for Restart Solution

Following build time flags are not set by default and can alter the behavior of the restart in Zynq UltraScale+ MPSoC:

Table 1. Build Time Flags
Component Flag Name Description
PMU firmware ENABLE_EM Enable error management and provide WDT interrupt handling. This is not directly related to restart solution but needed for recovery.
ENABLE_RECOVERY Enable Recovery during WDT expiry
ENABLE_ESCALATION Allow escalation on failure of boot or recovery
CHECK_HEALTHY_BOOT Use Healthy bit to determine escalation
IDLE_PERIPHERALS ENABLE_NODE_IDLING Both the flags must be used together to allow PMU firmware to attempt peripherals node idling (and reset).
REMOVE_GPIO_FROM_NODE_RESET_INFO Skips GPIO from the node idling and resetting list.

This is needed when the system is using GPIO to provide reset (or similar) signals to PL or other peripherals outside current subsystem.

If this flag is set, GPIO is not reset.

ATF ZYNQMP_WARM_RESTART=1 Enable WARM RESTART recovery feature in ATF that allow the CPU idling triggered from PMU firmware.
FSBL FSBL_PROT_BYPASS Skip XMPU/XPPU based configuration for system except for DDR and OCM.
Linux CONFIG_SRAM Needed for Remoteproc to work for load RPU images in the TCM.