VEK280 Hardware Setup - 6.0 English

MIPI CSI-2 Receiver Subsystem Product Guide (PG232)
Document ID
PG232
Release Date
2024-05-30
Version
6.0 English
  1. Set up the hardware connections as shown in the following figure.
    1. Mount the LI-IMX274MIPI-FMC Camera sensor module on the VEK280 board FMC Slot.
    2. Connect the HDMI cable to the VEK280 HDMI port.
    3. Connect the other end of the HDMI cable to the HDMI monitor.
    4. Switch on the HDMI monitor, and select HDMI as input source.
    5. Connect the USB-JTAG programming cable from host PC to JTAG type-C USB port of board.
    6. Ensure that the SD card, board switches and jumpers are in position as shown in the following figure. Connect the USB UART and JTAG programming cables to the Windows host computer where xsdb and hw_server is running.