The GT Selection and Configuration tab enables you to configure the serial transceiver features of the core.
Figure 1. GT Selection and Configuration Tab (Versal)
Figure 2. GT Selection and Configuration Tab
(UltraScale/UltraScale+)
| Option | Values | Default |
|---|---|---|
| GT Location | ||
| Select whether the GT IP is included in the core or in the example design |
Include GT subcore in core Include GT subcore in example design |
Include GT subcore in core |
| GT Clocks 2 | ||
| GT RefClk (In MHz) 1 |
161.1328125 195.3125 156.25 201.4160156 257.8125 322.265625 312.5 103.125 128.90625 206.25 309.375 |
161.1328125 |
| GT DRP Clock (In MHz) | 10 – 250 MHz | 100.00 |
| Core to GT Association | ||
| GT Type |
GTY GTH GTM |
GTY |
| GT Selection |
Options based on device/package Quad groups. For example: Quad X0Y1 Quad X0Y2 Quad X0Y3 ... |
Quad X0Y1 |
| Lane-00 to Lane-03 |
Auto filled based on device/package. For example, if Num of Core = 4, and GT Selection = Quad X0Y1, four lanes are: X0Y4 X0Y5 X0Y6 X0Y7 |
|
| RX Equalization Mode |
Auto LPM DFE |
Auto |
| RX Insertion Loss at Nyquist (dB) | Depends on the GT Wizard | 30 |
| Others | ||
| Enable Pipeline Registers | Checked, Unchecked | Unchecked |
| Enable Additional GT Control/Status and DRP Ports | Checked, Unchecked | Unchecked |
|
||