Performing What If? Analysis in the Vivado Integrated Design Environment - 2024.1 English

Vivado Design Suite User Guide: Power Analysis and Optimization (UG907)

Document ID
UG907
Release Date
2024-05-30
Version
2024.1 English

To perform What If? analysis, you can set toggle rates and static probability on nets and cells in the design. To make these settings, right-click any net or cell from the Netlist window or Power Report and click Properties, and go to the Power view in the Properties window as shown in the following figure. Then click the Load Properties button in the Power view. Click Edit Properties and set the Toggle Rate and Static Probability in the Edit Power Properties dialog box that appears, and click OK.

Figure 1. Power View in Net Properties Window

In the example above the Toggle Rate has been set to 1.5% and Static Probability is set to 0.8. On the Tcl Console the following XDC constraint will be displayed when the Vivado Integrated Design Environment commits the change on OK.

set_switching_activity -toggle_rate 1.500000 -static_probability 0.800000 [get_nets led]
Important: This XDC constraint makes your design out of date so use Force up-to-date to restore the design status.