Memory-Mapping in the Address Editor - 2022.1 English

MicroBlaze Processor Embedded Design User Guide (UG1579)

Document ID
Release Date
2022.1 English

While memory-mapping of the peripherals (slaves) instantiated in the block design are automatically assigned, you can manually assign the addresses also. To generate the address map for this design, do the following:

  1. Click the Address Editor tab above the diagram.
  2. Click the Assign All button.

You can manually set addresses by entering values in the Offset Address and Range columns. See section Creating a Memory Map in the Vivado Design Suite User Guide: Designing IP Subsystems using IP Integrator (UG994) for more information.

Figure 1. Memory-Mapping Peripherals
Tip: The Address Editor tab only opens if the diagram contains an IP such as the MicroBlaze device that functions as a bus master in the design.