The following figure shows the Customize IP dialog box with information about customizing parameters for the UHD-SDI Audio (Embed).
Figure 1. Re-customize IP
- Component Name
- Enter a name for the core instance. The Component Name is the base name of the output files generated for this core. This example uses the name v_uhdsdi_audio_embed.
- Audio Function
- Specifies the Audio Function. Available options:
- Embed
- Extract
- UHD-SDI Standard
-
Specifies the maximum line rate that should be supported. For 7 series speed grade 3, UltraScale and UltraScale+ devices, the available options are:
- 3G SDI
- 6G SDI
- 12G SDI 8DS
- 12G SDI 16DS
- Maximum Audio Channels
- Specifies the maximum number of audio channels that should be supported by
the UHD-SDI Audio (Embed) IP core. Available options:
- 2 (Audio can only be embedded onto group 1)
- 4 (Audio can only be embedded onto group 1)
- 6 (Audio can only be embedded onto group 1 & 2)
- 8 (Audio can only be embedded onto group 1 & 2)
- 10 (Audio can only be embedded onto group 1, 2 & 3)
- 12 (Audio can only be embedded onto group 1, 2 & 3)
- 14 (Audio can only be embedded onto group 1, 2, 3 & 4)
- 16 (Audio can only be embedded onto group 1, 2, 3 & 4)
- 32 (Audio can only be embedded onto group 1, 2, 3, 4, 5, 6, 7 & 8)
- Enable AXI4-Lite Interface
- when enabled, the AXI4-Lite interface is used for configuration. If it is not enabled, port based interface is chosen.
- Extract SDI Audio Status
- when enabled, UHD-SDI Audio (Embed) IP core reports the status of audio data present on the incoming SDI stream.
- Extract AES Channel Status
- when enabled, UHD-SDI Audio (Embed) IP core extracts 192 bit AES channel status.
- Enable Channel Padding
- when enabled, UHD-SDI Audio (Embed) IP core converts non-multiple of four channel AXI4-S transactions (2, 6, 10, etc.) to multiples of 4 channels (4, 8, 12, etc.) by stuffing the remaining two channels with mute data.