The Debugger Terminal is similar to the Xilinx System Debugger (XSDB).
All commands supported by XSDB syntax can be executed through the debugger terminal:
- After writing a command in the command line press Enter on the keyboard or click the SEND button to execute the command. To clear the command line input, click the CLEAR button.
- A series of commands can also be executed by uploading a file using the UPLOAD button (.tcl and .xregv files are supported). All commands supported by the Xilinx System Debugger (XSDB) are supported here with respect to the XSDB syntax.
- A progress bar is displayed as the file is being uploaded. The upload can be canceled by clicking the CANCEL button.
- The debugger stores the history of commands executed. You can retrieve previous commands using the command line input box and pressing the upward arrow key on the keyboard.
- Click the CLOSE button to clear the
debugger terminal console.Figure 1. Closing the Debugger Terminal
SysAddress Watch
The SysAddress Watch tab enables Versal ACAP addresses to be monitored.
- Any number of addresses can be monitored at a given time. The ACAP cockpit continuously reads the address and automatically updates the data displayed in the GUI table.
- You can download the register addresses and values displayed in the table by clicking the DOWNLOAD button.
- Click the STOP button to stop a watch (highlighted in yellow in the following figure).
- To monitor multiple addresses, list the address in the .tcl file and upload
the file by clicking the Upload
File... button (highlighted in green in the following
figure).Figure 2. SysAddress Watch
