Configure the Device via Dual QSPI

Fast Partial Reconfiguration Over PCI Express (XAPP1338)

Document ID
Release Date
1.0 English

A prom image of the design can be loaded into the local QSPI flash to be automatically delivered upon power-up of the board.

  1. Right-click the device (KU5P or VU9P), and select Add Configuration Memory Device.
  2. From the list of configuration memory parts, select mt25qu01g-spi-x1_x2_x4_x8. You must select this part (which includes _x8), because the PROM image is set for dual QSPI.

  3. Click OK, and then click OK again when asked if you want to program this device now.
  4. When asked if you want to program the device now, click OK, which opens Program Configuration Memory Device.

  5. For Configuration file, select PR_over_PCIe_prom_primary.mcs.
  6. For Configuration file 2, select PR_over_PCIe_prom_secondary.mcs.
  7. To erase the program from the flash target, click OK.
  8. After this completes, ensure the Mode pins are set to Master SPI mode before pushing PROG or re-powering the board.
  9. Ensure the following values are set to 0:
    Bit 6 on SW21
    Bit 2 on SW16