Confirm Firmware Installation

When a card has successfully been installed and the firmware has been updated, both entries for Platform and the satellite controller (SC) version installed on the card and the system must match. If they do not match, the system will be unable to correctly run applications on your card.

To confirm they match, run the following command and visually compare the 'Platform' and 'SC Version' entries under

Flashable
					partitions
					running on
				FPGA

and

Flashable partitions installed in
					system

match. See Obtaining Card BDF Values to obtain the device management BDF.

$ sudo /opt/xilinx/xrt/bin/xbmgmt examine --device <management BDF>

In the following example output, the Platform (xilinx_vck5000_gen3x16_xdma_base_1) and SC Version (4.4.12) displayed under Flashable partitions running on FPGA and Flashable partitions installed in system both match.

Flash properties
  Type                 : ospi_versal
  Serial Number        : XFL1MXCRDXXX

Device properties
  Type                 : vck5000
  Name                 : VCK5000-P
  Config Mode          : 8
  Max Power            : 300W

Flashable partitions running on FPGA
  Platform             : xilinx_vck5000_gen3x16_xdma_base_1
  SC Version           : 4.4.12
  Platform UUID        : 1E56042E-C345-CF41-5D66-4E9EE73451FC
  Interface UUID       : C9BFF99C-95E9-6917-ECDB-82F3C2927C27

Flashable partitions installed in system
  Platform             : xilinx_vck5000_gen3x16_xdma_base_1
  SC Version           : 4.4.12
  Platform UUID        : 1E56042E-C345-CF41-5D66-4E9EE73451FC


  Mac Address          : 00:0A:35:0D:09:98
                       : 00:0A:35:0D:09:99

Note: SC Version 4.4.9 incorrectly reports four MAC addresses instead of two. See Known Issues for additional details.