The GPIO, JTAG, HSDP, and MICTOR connectors are on the right side of the
SmartLynq+ Module, as shown in the following figure.
Figure 1. Target-Side Connections
For standard HSDP communication use the HSDP connector. Typically, this is the only connection required to a target board such as the Versal ACAP VCK190 evaluation board. For target boards without the HSDP connector use the 14 pin JTAG connector using a ribbon cable or flying leads. The GPIO cable provides additional low-speed signals for controlling the target or other instruments used alongside the board under test.