Step 8: Validating the Design - 2022.1 English

Vivado Design Suite Tutorial: Designing IP Subsystems Using IP Integrator (UG995)

Document ID
Release Date
2022.1 English
  1. From the menu at the top of the IP integrator design canvas, run the IP subsystem design rule checks (DRCs) by clicking the Validate Design button .

    The Validate Design dialog box opens, and validation should be successful.

  2. Click OK.
  3. Examine the interrupt bus width on the Interrupt Controller block.

    Notice, as shown in the following figure, that the width now matches the width of the bus signal coming from the Concat block. Parameter propagation has allowed the bus width to propagate through the subsystem design as needed.

    At this point, you should save the IP integrator subsystem design again.

  4. Select File > Save Block Design command from the main menu to save the design.