The following figure and table provide an overview of the physical connections, their designators, and relative position on the starter kit. The table uses the following abbreviations to indicate if a specific designator is located on the carrier card or on the SOM.
- CC = Device or interface is located on the carrier card
- SOM = Device or interface is located on the SOM
Figure 1. Interfaces and Connectors
Location | Name | Description |
---|---|---|
SOM DS34 | PS done LED | Lit indicates that the PS has successfully loaded a PL design. |
SOM DS35 | Heartbeat LED | Periodic flashing green LED driven by the Zynq UltraScale+ MPSoC APU processor. |
SOM DS36 | PS status LED | Status LED, when lit indicates a successful application load. |
CC DS1-DS6 | Power status LEDs | Indicates various power supply and power domain status. Green LED indicates good status. |
CC J2 | Pmod | Digilent Pmod 2x6 expansion header |
CC J3 | JTAG | Direct JTAG interface, bypasses the FTDI device. |
CC J4 | FTDI USB2.0 UART and JTAG | Integrated JTAG and device UART interface via USB2.0 |
CC J6 | DisplayPort | DisplayPort video output |
CC J5 | HDMI | HDMI™ video output |
CC J7 | IAS0 | OnSemi image access system (IAS) camera module interface supporting four MIPI lanes. Connects to OnSemi AP1302 ISP device sensor 0 interface. |
CC J8 | IAS1 | OnSemi IAS camera module interface supporting four MIPI lanes. Connected directly to the Zynq UltraScale+ MPSoC HPA bank. |
CC J9 | RPi camera | Raspberry Pi camera module interface. 15-pin variant supporting two MIPI lanes directly connected directly to the Zynq UltraScale+ MPSoC HPA bank. |
CC J10 | Ethernet RJ45 jack | 1 Gb/s Ethernet interface |
CC J11 | microSD card | microSD card boot device |
CC J12 | 12V power input | 12V power input jack |
CC J13 | Fan power | 12V SOM fan power interface |
CC SW1 | Firmware update button | Push button used during the boot firmware update process. |
CC SW2 | Reset button | Push button that resets the SOM via the device POR_B signal. |
CC U44 | USB0 | Two USB3.0 or USB2.0 compatible connectors |
CC U46 | USB1 | Two USB3.0 or USB2.0 compatible connectors |