Use the same setup as in Programming the Devices Using JTAG to ensure the ADK connector is attached.
- Ensure that an ADK cable is connected between the ADK connector on the T2 card and the USB port on the host machine. The T2 with an ADK connected is shown in Programming the Devices Using JTAG.
- In the Vitis™ environment, create a new hardware project using the Zynq UltraScale+ RFSoC.
- In the Vitis environment, select .
- Select the hardware platform generated in step 2.
- In the Program Flash wizard, browse to and select the BOOT.bin image file that was created for the Zynq UltraScale+ RFSoC.
- Select fsbl.elf as the init file.
- Select qspi-x8_dual_parallel as the flash type.
- Set the offset as 0.
- Click Program to start programming the QSPI flash with the BOOT.bin file.
- Wait until you see the message “Flash Operation Successful” in the Vitis console.