The following table shows the revision history for this document.
Section | Revision Summary |
---|---|
12/13/2023 Version 1.4 | |
SYSMON Architecture | Added reference to temperature measurements. |
SYSMON Dedicated Pinout Requirements | Added voltage and temperature alarms to SMBALERT. |
Alarms | |
Over-Temperature Shutdown | Added information on the error response. |
Analog Power Supply and Ground | Updated Figure 1. |
Considerations for Stacked Silicon Interconnect Technology | Added information for temperature readings. |
SYSMON Registers | Updated module names. |
I2C or PMBus Interface | Added information on access to SYSMON registers. |
PMBus Transfer Commands | Updated Table 1. |
PMBus Example | |
05/17/2022 Version 1.3 | |
SYSMON Architecture | Added note about SLR. |
Temperature Sensor |
Updated to address temperature variation. Added reference. |
Averaging | Updated temperature sensor voltage averaging. |
Analog Power Supply and Ground | Removed additional regulator recommendation. |
Analog Input Description | Removed additional regulator recommendation. |
Configuring the SYSMON | Updated information on CIPS configuration flow. |
I2C or PMBus Interface | Added table to address reserved I2C/PMBus slave
addresses. Added references. |
04/19/2021 Version 1.2 | |
SYSMON Dedicated Pinout Requirements | Updated to indicate that VCCAUX_SMON must be tied to the VCCAUX_PMC supply. |
Over-Temperature Shutdown | Updated to clarify PMC behavior. |
I2C Interface | Clarified description. |
12/04/2020 Version 1.1 | |
SYSMON Architecture | Updated PMC main switch description as well as updated the figure to remove DXP/DXN ports. |
SYSMON Supply and Reference Requirements | Updated recommendation to use internal reference. |
SYSMON Dedicated Pinout Requirements | Updated package pinout names. |
Differences from Previous Generations | Added information about improved noise immunity. |
Analog Channels | Added details about CIPS behavior. |
Supply Sensors | Added a note about IR drop consideration. |
Bank Ground | Added information on how to enable bank GND. |
External Multiplexer Functionality | Removed section. |
Averaging | Added a reference to averaging control register, as well as added a note to explicitly call out shared averaging levels. |
Maximum/Minimum Tracking | Updated description. |
Alarms | Added register details and information about alarm behavior. |
Over-Temperature Shutdown | Added references to registers. |
Analog Power Supply and Ground | Updated to recommend the use of on-chip reference. |
Analog Input Description | Clarified description. |
Configuring the SYSMON | Added details about using the CIPS wizard. |
Accessing the PMC and Processing System Considerations | Added section. |
SYSMON Registers | Added information about interrupts as well as other SYSMON registers. |
07/16/2020 Version 1.0 | |
Initial release. | N/A |