Click Run Block Automation, as shown below.
The Run Block Automation dialog box opens.
On the Run Block Automation dialog box:
a. Leave Preset as the default value, None.
b. Set Local Memory to 64 KB.
c. Leave the Local Memory ECC as the default value, None.
d. Set Cache Configuration to 32 KB.
e. Set Debug Module to Debug Enabled.
f. Leave the Peripheral AXI Port option as the default value, Enabled.
g. Leave the Interrupt Controller option unchecked.
h. Leave The Clock source option set to /mig_7series_0/ui_addn_clk_0 (100 MHz).
Click OK.
This generates a basic MicroBlaze V system in the IP integrator diagram area, as shown in the following figure.
