Step 12: Running Demo on ZCU102 Board - XAPP1361

Isolation Design Flow + Dynamic Function eXchange Example Application Note (XAPP1361)
Document ID
XAPP1361
Release Date
2024-05-23
Revision
1.2 English
  1. Copy the BOOT.bin to the ZCU102 SD card, that was created in the previous step.
  2. Connect the UART cable and power cable to the board. Set the COM port to an appropriate value for your computer. Set the Baud Rate to 115200. Open a UART terminal to communicate with the software running on the PS.
  3. Configure the board to boot in SD-Boot mode by setting switch SW6 to 1-ON, 2-OFF, 3-OFF, and 4-OFF as shown in the following figure.

  4. Load the SD card into the ZCU102 board and power up the board. You can see the boot image loaded successfully and the LEDs blink.

    In the UART terminal, you can see the software menu to load the partial bitstreams as shown in the following image..

  5. Enter your inputs to load different partial bitstreams. You can see the LEDs pattern change on the board after each reconfiguration. The following image shows the UART terminal after loading shift_left and count_down partials.