Vivado Project Creation - Vivado Project Creation - XAPP1336

Isolation Design Example for the Zynq UltraScale+ MPSoC (XAPP1336)
Document_ID
XAPP1336
Release_Date
2023-10-20
Revision
2.1 English
  1. Set up a new Vivado project:
    • From the Quick Start menu, click Create New Project, and wait for the New Project - Create a New Vivado Project window to pop up. You may refer to the following figure. Select Next.
  2. In the New Project Project Name window enter:
    • Project name: XAPP1336_LAB (project name used for this lab).
    • Project location: ZUP_LAB (path to the directory).
    • Check Create project subdirectory checkbox.
  3. Click Next.
  4. Select RTL Project and check Do not specify sources at this time.
  5. Click Next.
  6. Select xczu5cg-sfvc784-1-e in the default window, as shown in the following figure. Type the part name as xczu5cg-sfvc784-1-e and select the device from the results.
  7. Click Next.
  8. Click Finish on the New Project Summary window.
    Note: The Vivado project is now created. The following figure shows the project manager window for the project created.
  9. Click Edit in the Project Summary window and change Target Language to VHDL.