Referring to the following
figure:
Figure 1. Connection Diagram for Preliminary Setup
- Place switch SW1 to the OFF position and connect the power supply to J15.
- Connect the USB cables between the computer and the UART connector (J4) and JTAG connector (J87) on the KCU105 board and the computer.
- Set the FPGA M2 pin to 0 by setting DIP switch SW15-6, to OFF as shown in the preceding figure. This selects the FPGA SPI configuration mode (M[2:0] = 001) because the FPGA M[1:0] pins are hard-wired to 01. Ensure DIP switch SW15-5 is in OFF position to disable the SYSCTLR_ENABLE.