Top Down Design Flow - 2024.1 English

In this flow, a diagram for the top-level block design is created first. The designer or a team lead then creates proper hierarchies in the top-level block design to push a set of IP blocks into Block Design Containers as sub-blocks. Follow the steps below, in sequence, to create a Block Design Container in a diagram:

1. Create a level of hierarchy in the top-level block design. Create a hierarchical block in a diagram by selecting one or more IP blocks and then right-click to select Create Hierarchy as described in Creating Hierarchies.
2. Once a hierarchical block is created and the desired IP blocks are contained in it run Validate Design.
3. Once design validation is successful, right-click on the hierarchical block and select Create Block Design Container as shown in the following figure.
   Figure 1. Create Block Design Container Command
4. Specify a name for the Block Design Container.
5. The IP integrator then creates a new Block Design Container (BDC) for that level of hierarchy containing the selected blocks. Note the following:
   • The BDC name specified in the previous step is assigned to the .bd source file of the BDC. For example, in the following image BDC_0 is the specified name for the BDC and therefore BDC_0.bd is the assigned name for the created .bd source file.
     Figure 2. Block Design Container
   • The BDC .bd source file gets added to the project sources as shown in the image below.
     Figure 3. BDC in Sources Window