- If HDL instantiation was done with System ILA, then select and right-click the net marked for debug in the block design.
- Clear Debug option can be selected from the context menu. This removes the connection between the net marked for debug and the System ILA and also re-configures the ILA to debug only the other nets. If there are no nets to be debugged, then the System ILA is deleted.
In some cases, you might want to keep the debugging logic within the
block design as it is, but, want to exclude the debugging logic from the generated
HDL. To support this, block designs have an EXCLUDE_DEBUG_LOGIC property, which can be enabled in the Properties
window or through the set_property Tcl command,
specified as follows:
set_property EXCLUDE_DEBUG_LOGIC 1 [get_files
C:/Temp/base_mb_kc705/base_mb_kc705.srcs/sources_1/bd/base_mb/base_mb.bd]With the block design selected in the Sources window, check the
EXCLUDE_DEBUG_LOGIC property in the Source File
Properties window, as shown in the following figure.
If netlist insertion flow was used to insert an ILA after synthesis, then you must remove the ILA manually. To do this, open the netlist after synthesis and in the Existing Debug Nets page of the Debug wizard, select Disconnect all nets and remove debug cores.
