Description
Branch if rA is greater or equal to 0, to the instruction located in the offset value of rB. The target of the branch will be the instruction at address PC + rB.
The mnemonic bged will set the D bit. The D bit determines whether there is a branch delay slot or not. If the D bit is set, it means that there is a delay slot and the instruction following the branch (that is, in the branch delay slot) is allowed to complete execution before executing the target instruction. If the D bit is not set, it means that there is no delay slot, so the instruction to be executed after the branch is the target instruction.
Pseudocode
If rA >= 0 then
PC ← PC + rB
else
PC ← PC + 4
if D = 1 then
allow following instruction to complete execution
Registers Altered
- PC
Latency
- 1 cycle (if branch is not taken)
- 2 cycles (if branch is taken and the D bit is set with
C_AREA_OPTIMIZED
≠2) - 3 cycles (if branch is taken and the D bit is not set with
C_AREA_OPTIMIZED
≠2) - 6 cycles (if branch is taken and the D bit is set with
C_AREA_OPTIMIZED
=2) - 7 cycles (if branch is taken and the D bit is not set with
C_AREA_OPTIMIZED
=2)
If C_USE_MMU
> 1 two additional cycles are added with
C_AREA_OPTIMIZED
=2.
Note
A delay slot must not be used by the following: imm, branch, or break instructions. Interrupts and external hardware breaks are deferred until after the delay slot branch has been completed.