To disable the JTAG interface through the eFUSE registers, run the following Tcl command:
program_hw_devices -force_efuse -security_efuse {08} [lindex [get_hw_devices] $deviceIdx]Where $deviceIdx is set to the index of the
UltraScale or UltraScale+ device that has its JTAG interface disabled.
Important: The Tcl
command to disable the JTAG interface for 7 series differs from command used previously for UltraScale or UltraScale+ devices. If a 7 series device is used, see the entry for
XSK_EFUSEPL_DISABLE_JTAG_CHAIN listed in Answer Record 65110.Note: This programming step should be performed as the
last and final step after all desired eFUSE bits are programmed.
Important: If the JTAG Disable bit is
programmed, the JTAG interface is disabled, preventing future test and configuration
access to the device. This bit should only be programmed if JTAG access to the device is
no longer required.