By default, the SmartLynq module uses the following ports. In some cases, you
might want to change the port used. To update the port used, add the commands to the
SmartLynq config.ini file and update using the procedure documented
in the
SmartLynq Data Cable User Guide (UG1258).
| Default Port | Description | Add to config.ini to change |
|---|---|---|
| 80 | TCF over HTTP |
set http-port
<port>
|
| 3121 | TCF |
set tcf-port
<port>
|
| 10200 | Low level JTAG access over XVC |
set xvc-port
<port>
|
| 3000-3005 | GNU Debugger ports (for Arm® / MicroBlaze™ processors) |
set gdb-port <base
port>
Setting the base port sets the lowest port for the range of four ports. |