Start your analysis with the Design Runs window. This window shows the current state of each run, including whether it is running, completed successfully, or completed with errors. For details about schematic-based analysis, see Using the Schematic Window in the Vivado Design Suite User Guide: Using the Vivado IDE (UG893).
Figure 1.
Design Runs Window
The Design Runs window includes the following columns:
- Name
- Name of the run and target part.
- Constraints
- Constraints set used in the run.
- Status
- Status of the last completed step.
- WNS, TNS, WHS, THS, WBSS, TPWS
- Timing score of the run used to quickly check timing results. If timing is not
met, begin analysis with the Timing Summary Report. See Report Timing Summary for more information on these numbers. Note: WBSS represents the Worst Bus Skew Slack reported by
report_bus_skew. - Total Power
- Total power estimate
It also provides the following information:
- The run strategy.
- The progress of a run.
- The start time of a run.
- The elapsed time of a run during execution or the final runtime of a completed run.
- The number of nets that were not successfully routed.
- The utilization of the design LUT, FF, block RAMs, DSP, and if applicable, UltraRAMs.
- A brief description of the run strategy.
- Methodology check violations.
- Available QoR suggestions.
- The incremental mode of the design run.
To analyze a run, right-click the run and choose from several actions such as opening the run or setting up incremental compile and QoR suggestions.