The dataflow viewer is only for netlist analysis of a dataflow-optimized netlist. Because of this, many commands are not supported with the dataflow design.
Unsupported commands include, but are not limited to, the following:
- Examples of timing commands include:
-
report_timing -
report_clock_interaction -
create_clock -
set_max_delay - Any timing constraint or timing report
-
- Examples of ECO commands include:
-
create_cell -
create_net -
create_pin -
connect_net
-
- Examples of implementation commands include:
-
synth_design -
opt_design -
place_design -
phys_opt_design -
route_design -
write_device_image
-
- Examples of reporting commands include:
-
report_high_fanout_nets -
report_control_sets -
report_clock_utilization -
report_ram_utilization -
report_design_analysis -
report_qor_suggestions -
report_qor_assessment
-