The Program section of the ECO Navigator provides access to the commands. These commands allow you to save your modifications and generate a new BIT file for programming. You can slo generate a new LTX file for your debug probes and program the device.
Figure 1. ECO Navigator Program
Commands
- Save Checkpoint As
- This command allows you to save your modifications to a new checkpoint.Figure 2. Save Checkpoint As Dialog Box
- Generate Bitstream
- This command allows you to generate a new .bit file for programming for 7
series and UltraScale, UltraScale + devices. For Versal devices, the Generate Device Image
command is used.Figure 3. Generate Bitstream Dialog Box
- Write Debug Probes
- This command allows you to generate a new .ltx file for your debug probes. If you made changes to your
debug probes using the Replace Debug
Probes command, save the updated information to a
new debug probes file (LTX). It reflects the changes in the Vivado Hardware Manager.Figure 4. Write Debug Probes Dialog Box