Entering Assign Routing Mode - Entering Assign Routing Mode - 2025.2 English - UG904

1. Open Device window.
2. Make sure to select Routing Resources in the Device window.
3. Enable the Layers for Unrouted Net and Partially Routed Net in the Device Options Layers view, shown in the following figure.
   
   
4. Select the net that requires routing.
   • Unrouted nets are indicated by a red flyline.
   • Partially routed nets are highlighted in yellow.
5. Right-click and select Enter Assign Routing Mode.

   The Assign Routing Mode: Target Load Cell Pin dialog box opens.

6. Optionally, select a load cell pin to which you want to route.
7. Click OK.
   Note: To display partially routed or unrouted nets in the Device window, ensure to select those layers in the Device Options menu.
   
   
   

You are now in Manual Routing Mode. A Routing Assignment window, shown in the following figure, appears next to the Device window.