The following SDC commands are not supported.
-
set_clock_gating_check -
set_clock_transition -
set_ideal_latency -
set_ideal_network -
set_ideal_transition -
set_max_fanoutNote: Maximum fanout is controlled by the MAX_FANOUT attribute during synthesis. -
set_drive -
set_driving_cell -
set_fanout_load -
set_input_transition -
set_max_area -
set_max_capacitance -
set_max_transition -
set_min_capacitance -
set_port_fanout_number -
set_resistance -
set_timing_derate -
set_voltage -
set_wire_load_min_block_size -
set_wire_load_mode -
set_wire_load_model -
set_wire_load_selection_group -
create_voltage_area -
set_level_shifter_strategy -
set_level_shifter_threshold -
set_max_dynamic_power -
set_max_leakage_power