The JTAG_STATUS register indicates the value of global signals and select dedicated configuration status pins and signals. A detailed explanation of each bit position is given in the following table.
| Name | Bit Index | Description |
|---|---|---|
| RSVD READS 0 | 47 | Reserved reads 0 |
| INIT_COMPLETE | 46 | Device initialization complete |
| DCI_LOCK | 45 | DCI lock status |
| PLL_LOCK | 44 | PLL/DDRMC lock status |
| EOS | 43 | End of Startup |
| GWE | 42 | Global write enable |
| GTS CFG | 41 | Global tri-state |
| GHIGH | 40 | Global GHIGH |
| RESERVED | 39:37 | Reserved |
| PUDC_B | 36 | Value on the PUDC_B pin. |
| RESERVED | 35 | Reserved |
| DONE | 34 | Value on the DONE_PIN pin. A value of 1 on DONE indicates boot and configuration is complete. |
| JRDBK ERROR | 33 | JTAG readback status indicator. A value of 1 on JRDBK indicates an error reading data from the slave boot interface (SBI). |
| JCONFIG ERROR | 32 | JTAG data load error indicator. A value of 1 indicates the SBI is not ready to accept data. |
| PMC VERSION | 31:28 | PMC version |
| RESERVED | 27:24 | Reserved |
| JTAG SEC GATE | 23 | Security gate status. |
| RESERVED | 22 | Reserved |
| PMC SCAN CLEAR DONE | 21 | Scan clear done indicator. A value of 1 indicates the scan clear is complete. |
| PMC SCAN CLEAR PASS | 20 | Scan clear pass indication. A value of 1 means the scan clear passed. |
| CRP JTAG STATUS | 19:17 | Clock and reset status. A value of 3'b111 indicates the device is still held in POR reset. |
| RESERVED | 16:15 | Reserved |
| BOOT MODE | 14:12 | Value on the M[2:0] mode pins at release of PROGRAM_B. |
| RESERVED | 11:8 | Reserved |
| AES KEY ZEROIZED | 7 | AES key zeroized indicator. A value of 1 indicates all keys are zeroized. |
| RESERVED | 6 | Reserved |
| SELECTMAP BUS WIDTH | 5:4 | SelectMAP configuration mode bus width detected.
|
| SBI JTAG ENABLED | 3 | SBI JTAG indicator. A value of 1 indicates the SBI is configured to receive data from the JTAG interface. |
| SBI JTAG BUSY | 2 | SBI JTAG busy indicator. A value of 1 indicates the SBI is busy and cannot accept data when in JTAG mode. |
| RSVD READS 0 | 1 | Reserved reads 0 |
| RSVD READS 1 | 0 | Reserved reads 1 |