Sleep Mode - Sleep Mode - 1.15 English - UG585

Zynq 7000 SoC Technical Reference Manual (UG585)

Document_ID
UG585
Release_Date
2026-02-06
Version
1.15 English

Sleep mode can be used to save a small amount of power during idle times. When in sleep mode, the controller can transition to normal mode or configuration mode. In sleep mode:

  • When another node transmits a message, the controller receives the message and exits sleep mode.
  • If there is a new TX request then the hardware switches the controller to normal mode and the controller services the request(s).
  • An interrupt can be generated when the controller enters sleep mode.
  • An interrupt can be generated when the controller wakes up.

Sleep mode is exited by the hardware when there is CAN bus activity or a request in either TxFIFO or TxHPB. When the controller exits sleep mode, can.MSR[SLEEP] is set to 0 by the hardware and an interrupt can be generated.

The CAN controller enters Sleep mode from Configuration mode when the LBACK bit in MSR is 0, the SLEEP bit in MSR is 1, and the CEN bit in SRR is 1. The CAN controller enters Sleep mode only when there are no pending transmission requests from either the TX FIFO or the TX High Priority Buffer.

The CAN controller enters Sleep mode from Normal mode only when the SLEEP bit is 1, the CAN bus is idle, and there are no pending transmission requests from either the TX FIFO or TX High Priority Buffer.

When another node transmits a message, the CAN controller receives the transmitted message and exits Sleep mode. When the controller is in Sleep mode, if there are new transmission requests from either the TX FIFO or the TX High Priority Buffer, these requests are serviced, and the CAN controller exits Sleep mode. Interrupts are generated when the CAN controller enters Sleep mode or wakes up from Sleep mode. From sleep mode, the CAN controller can enter either the Configuration or Normal modes.