Register XUSBPS_TXFILL_OFFSET Details - Register XUSBPS_TXFILL_OFFSET Details - 1.15 English - UG585

Zynq 7000 SoC Technical Reference Manual (UG585)

Document_ID
UG585
Release_Date
2026-02-06
Version
1.15 English

The fields in this register control performance tuning associated with how the Controller posts data to the TX latency FIFO before moving the data onto the USB bus.

Field Name Bits Type Reset Value Description

XUSBPS_TXFILL_BURST_MASK

(BURST)

21:16 rw 0x0

FIFO Burst Threshold:

This register controls the number of data bursts that are posted to the TX latency FIFO in host mode before the packet begins on to the bus. The minimum value is 2 and this value should be a low as possible to maximize USB performance. A higher value can be used in systems with unpredictable latency and/or insufficient bandwidth, where the FIFO may under run because the data transferred from the latency FIFO to USB occurs before it can be replenished from system memory. This value is ignored if the Stream Disable bit in USBMODE register is set (SDIS).

reserved 15:13 ro 0x0 reserved

XUSBPS_TXFILL_HEALTH_MASK

(HEALTH)

12:8 rw 0x0

Scheduler Health Counter.

This register increments when the Controller fails to fill the TX latency FIFO to the level programmed by TXFIFOTHRES before running out of time to send the packet before the next Start-Of-Frame.

This health counter measures the number of times this occurs to provide feedback to selecting a proper TXSCHOH. Writing to this register will clear the counter. This counter will max. at 31.

reserved 7 ro 0x0 RESERVED

XUSBPS_TXFILL_OVERHEAD_MASK

(OVERHEAD)

6:0 rw 0x0

Scheduler Overhead.

This register adds an additional fixed offset to the schedule time estimator described above as Tff. As an approximation, the value chosen for this register should limit the number of back-off events captured in the TXSCHHEALTH to less than 10 per second in a highly utilized bus. Choosing a value that is too high for this register is not desired as it can needlessly reduce USB utilization.

The time unit represented in this register is 1.267us when a device is connected in High-Speed Mode for OTG(on the go) & SPH(single port host) implementations.

The time unit represented in this register is 6.333us when a device is connected in Low/Full Speed Mode for OTG & SPH implementations. The time unit represented in this register is always 1.267us for the MPH implementation.