Register XTTCPS_CNT_CNTRL_OFFSET Details - Register XTTCPS_CNT_CNTRL_OFFSET Details - 1.15 English - UG585

Zynq 7000 SoC Technical Reference Manual (UG585)

Document_ID
UG585
Release_Date
2026-02-06
Version
1.15 English
Field Name Bits Type Reset Value Description

XTTCPS_CNT_CNTRL_POL_WAVE_MASK

(POL_WAVE)

6 rw 0x0 Waveform polarity: When this bit is high, the waveform output goes from high to low on Match_1 interrupt and returns high on overflow or interval interrupt; when low, the waveform goes from low to high on Match_1 interrupt and returns low on overflow or interval interrupt.

XTTCPS_CNT_CNTRL_EN_WAVE_MASK

(EN_WAVE)

5 rw 0x1 Output waveform enable, active low.

XTTCPS_CNT_CNTRL_RST_MASK

(RST)

4 rw 0x0 Setting this bit high resets the counter value and restarts counting; the RST bit is automatically cleared on restart.

XTTCPS_CNT_CNTRL_MATCH_MASK

(MATCH)

3 rw 0x0 Register Match mode: when Match is set, an interrupt is generated when the count value matches one of the three match registers and the corresponding bit is set in the Interrupt Enable register.

XTTCPS_CNT_CNTRL_DECR_MASK

(DECR)

2 rw 0x0 Decrement: when this bit is high the counter counts down.

XTTCPS_CNT_CNTRL_INT_MASK

(INT)

1 rw 0x0 When this bit is high, the timer is in Interval Mode, and the counter generates interrupts at regular intervals; when low, the timer is in overflow mode.

XTTCPS_CNT_CNTRL_DIS_MASK

(DIS)

0 rw 0x1 Disable counter: when this bit is high, the counter is stopped, holding its last value until reset, restarted or enabled again.