Register DDRIOB_CLOCK Details - Register DDRIOB_CLOCK Details - 1.15 English - UG585

Zynq 7000 SoC Technical Reference Manual (UG585)

Document_ID
UG585
Release_Date
2026-02-06
Version
1.15 English
Field Name Bits Type Reset Value Description
reserved 31:12 rw 0x0 Reserved
PULLUP_EN 11 rw 0x1

enables pullup on output

0: no pullup

1: pullup enabled

OUTPUT_EN 10:9 rw 0x0

Enables output mode to enable output ties to

00: ibuf

01 and 10: reserved

11: obuf

TERM_DISABLE_MODE 8 rw 0x0

Termination is used during read transactions and may be disabled (automatically by hardware) when there are no reads taking place through the DDR Interface. Disabling termination reduces power consumption.

0: termination always enabled

1: use 'dynamic_dci_ts' to disable termination when not in use
Note: This bit must be 0 during DRAM init/training. It may be set to 1 after init/training completes.
IBUF_DISABLE_MODE 7 rw 0x0

Use ibuf_disable_into control ibuf

0: ibuf is enabled

1: use ibuf_disable_in_to control enable
Note: This must be 0 during DRAM init/training and can only be set to 1 after init/training completes.
DCI_TYPE 6:5 rw 0x0

DCI Mode Selection:

00: DCI Disabled (DDR2/3L ADDR and CLOCK)

01: DCI Drive (LPDDR2)

10: reserved

11: DCI Termination (DDR2/3/3L DATA and DIFF)

TERM_EN 4 rw 0x0

Tri State Termination Enable:

0: disable

1: enable

DCI_UPDATE_B 3 rw 0x0

DCI Update Enable:

0: disable

1: enable

INP_TYPE 2:1 rw 0x0

Input buffer control:

00: Input off (input signal to selected controller is driven Low).

01: Vref based differential receiver for SSTL, HSTL.

10: Differential input receiver.

11: LVCMOS receiver.

reserved 0 rw 0x0 Reserved. Do not modify.