The UART continuously over-samples the UARTx_RxD signal using UARTx REF_CLK and the clock enable (baud_sample). When the samples detect a transition to a Low level, it can indicate the beginning of a start bit. When the UART senses a Low level at the UART_RxD input, it waits for a count of half of BDIV baud rate clock cycles, and then samples three more times. If all three bits still indicate a Low level, the receiver considers this to be a valid start bit, as illustrated in the following figure for the default BDIV of 15.
When a valid start bit is identified, the receiver baud rate clock enable (baud_rx_rate) is re-synchronised so that further sampling of the incoming UART RxD signal occurs around the theoretical mid-point of each bit, as illustrated in the following figure.
When the re-synchronised baud_rx_rate is High, the last three sampled bits are compared. The logic value is determined by majority voting; two samples having the same value define the value of the data bit. When the value of a serial data bit has been determined, it is shifted to the receive shift register. When a complete character has been assembled, the contents of the register are then pushed to the RxFIFO.