Quad-SPI Feedback Clock - Quad-SPI Feedback Clock - 1.15 English - UG585

Zynq 7000 SoC Technical Reference Manual (UG585)

Document_ID
UG585
Release_Date
2026-02-06
Version
1.15 English

The Quad-SPI interface supports an optional feedback clock pin named qspi_sclk_fb_out. This pin is used with the high speed Quad-SPI timing mode, where the memory interface clock needs to be greater than 40 MHz. The feedback signal is received from the internal input from the I/O so MIO pin 8 needs to be programmed and allowed to freely toggle. Refer to optional programming example in MIO Programming for instructions on how to program the MIO_PIN_08 register.

When Quad-SPI feedback mode is used, the qspi_sclk_fb_out pin should only be connected to a pull-up or pull-down resistor which is needed to set the MIO voltage mode (vmode).

When operating at a Quad-SPI clock frequency greater than FQSPICLK2, the MIO 8 pin must be programmed as the feedback output clock and the MIO 8 pin must only be connected to a pull-up/pull-down resistor on the PCB for boot strapping.