The Quad-SPI flash memory signals are routed through the MIO multiplexer to the MIO device pins. Each side of the dual controller port can be individually enabled or operate together as an 8-bit I/O interface.
The Quad-SPI flash memory signals are routed to the MIO pins as shown in the following table.
| Quad-SPI Flash Memory Interface | MIO Pin | Controller Default Input Value | ||||||
|---|---|---|---|---|---|---|---|---|
| Signal | I/O Mode for Data | Quad SPI 0 | Quad SPI 1 | I/O | Name | |||
| 1-Bit Data | 2-Bit Data | 4-Bit Data | ||||||
| Flash Chip Select | ~ | 1 | 0 | O | QSPI{1,0}_SS_B | ~ | ||
| Serial Clock | ~ | 6 | 9 | O | QSPI{1,0}_SCLK | ~ | ||
| Output Feedback Clk | ~ | 8 | O | QSPI_SCLK_FB_OUT | ~ | |||
| I/O 0 | Master Output | I/O 0 | I/O 0 | 2 | 10 | IO | QSPI{1,0}_IO_0 | 0 |
| I/O 1 | Master Input | I/O 1 | I/O 1 | 3 | 11 | IO | QSPI{1,0}_IO_1 | 0 |
| I/O 2 | Write Protect | Write Protect | I/O 2 | 4 | 12 | IO | QSPI{1,0}_IO_2 | 0 |
| I/O 3 | Hold | Hold | I/O 3 | 5 | 13 | IO | QSPI{1,0}_IO_3 | 0 |