Data Phase - Data Phase - 1.15 English - UG585

Zynq 7000 SoC Technical Reference Manual (UG585)

Document_ID
UG585
Release_Date
2026-02-06
Version
1.15 English

Following the setup phase, the DCD must create a device transfer descriptor for the data phase and prime the transfer.

After priming the packet, the DCD must verify a new setup packet has not been received by reading the usb.ENDPTSETUPSTAT register immediately verifying that the prime had completed. A prime completes when the associated bit in the usb.ENDPTPRIME register is 0 and the associated bit in the usb.ENDPTSTATUS register is a 1. If a prime fails, that is, the usb.ENDPTPRIME bit goes to 0 and the usb.ENDPTSTATUS bit is not set, then the prime has failed. This can only be due to improper setup of the dQH, dTD or a setup arriving during the prime operation. If a new setup packet is indicated after the endpoint prime bit is cleared, then the transfer descriptor can be freed and the DCD must reinterpret the setup packet.

Should a setup arrive after the data stage is primed, the device controller automatically clears the prime status (usb.ENDPTSTATUS) to enforce data ordering with the setup packet.

Note: The dQH.Mult field must be set to 00 for bulk, interrupt, and control endpoints. Error handling of data phase packets is the same as bulk packets described previously.