IOBUF_DCIEN

UltraScale Architecture SelectIO Resources User Guide (UG571)

Document ID
UG571
Release Date
2023-08-31
Revision
1.15 English

The IOBUF_DCIEN primitive shown in This Figure is available in the HP I/O banks. It has an IBUFDISABLE port that can be used to disable the input buffer during periods that the buffer is not being used. The IOBUF_DCIEN primitive also has a DCITERMDISABLE port that can be used to manually disable the optional on-die receiver termination features (uncalibrated and DCI). See the DCI—Only Available in the HP I/O Banks and Uncalibrated Input Termination in I/O Banks sections for more details.

Figure 1-31: Input/Output Buffer DCI Enable Primitive (IOBUF_DCIEN)

X-Ref Target - Figure 1-31

X16090-input_output-buffer-dci-enable-primitive-iobuf_dcien.jpg

The IOBUF_DCIEN primitive can disable the input buffer and force the O output to the internal logic to a logic-Low when the IBUFDISABLE signal is asserted High and output buffer is 3-stated (T = High). If the I/O is using any on-die receiver termination features (uncalibrated and DCI), this primitive disables the termination legs whenever the DCITERMDISABLE signal is asserted High and the output buffer is 3-stated (T = High). When the output buffer is 3-stated (T = High), the input buffer and any on-die receiver termination (uncalibrated or DCI) are controlled by IBUFDISABLE and DCITERMDISABLE, respectively. The USE_IBUFDISABLE attribute must be set to TRUE, the IBUFDISABLE port must be controlled, and SIM_DEVICE set to ULTRASCALE for this primitive to have the expected behavior that is specific to the UltraScale architecture. When the output buffer is not 3-stated (T = Low), the input buffer and any on-die receiver termination (uncalibrated or DCI) are disabled and the O output (to the internal logic) is forced to a logic-Low. These features can be combined to reduce power whenever the input is idle for a period of time. Although uncommon, if a design requires an input be constantly enabled while maintaining the ability to dynamically control DCI, this primitive can be used by floating the IBUFDISABLE pin and setting the USE_IBUFDISABLE attribute to FALSE.