The AMD Vivado™ , AMD SDK, or third-party tools can establish a JTAG connection to the Spartan UltraScale+ device in the two ways described in this section.
- FTDI FT4232 USB-to-JTAG/USB-UART device (U11) connected to USB 2.0 type-C
connector (J7), which requires:
- Set boot mode selection header J35 for JTAG as indicated in the "Mode Configuration Header J35 Option Settings" table in Spartan UltraScale+ Device Configuration.
- Power-cycle the evaluation board or press the program (PROGRAM_B) pushbutton (SW2). SW2 is near the HSIO connector J21 in the figure in Board Component Location.
- JTAG pod flat cable connector J5 (2 mm 2x7 shrouded/keyed), which
requires:
- Set boot mode selection header J35 for JTAG as indicated in the "Mode Configuration Header J35 Option Settings" table in Spartan UltraScale+ Device Configuration.
- Power-cycle the SCU35 board or press the program (PROGRAM_B) pushbutton (SW2). SW2 is near the HSIO connector J21 in the figure in Board Component Location.
Note: In this mode, the FT4232 device (U11) UART functionality continues to be available.