Memory-Mapping in the Address Editor - 2024.1 English

The memory-mapping of the peripherals (slaves) instantiated in the block design are automatically assigned, but you can also assign the addresses manually. Perform the following steps to generate the address map for this design.

1. Click the Address Editor tab above the diagram.
2. Click the Assign All button. Set addresses by entering values in the Offset Address and Range columns. See section Addressing for Block Designs in the Vivado Design Suite User Guide: Designing IP Subsystems using IP Integrator (UG994) for more information.
   Tip: The Address Editor tab only opens if the Diagram contains an IP. For example, a MicroBlaze V device that functions as a bus master in the design.
   Figure 1. Memory-Mapping Peripherals