IRQ_STATUS (SBI) Register Description
| Register Name | IRQ_STATUS |
|---|---|
| Offset Address | 0x0000000300 |
| Absolute Address | 0x0004110300 () |
| Width | 32 |
| Type | mixedMixed types. See bit-field details. |
| Reset Value | 0x00000000 |
| Description | SBI Interrupt Status Register. This is a sticky register that holds the value of the interrupt. Writing a 1 will clear the status. |
IRQ_STATUS (SBI) Register Bit-Field Summary
| Field Name | Bits | Type | Reset Value | Description |
|---|---|---|---|---|
| Reserved | 31:12 | razRead as zero | 0x0 | Reserved |
| MCAP_RESET_SEEN | 11 | wtcReadable, write a 1 to clear | 0x0 | 1: When mcap_reset is set, write 1 to clear this bit when mcap_reset service is complete. |
| MCAP_MODE_FE | 10 | wtcReadable, write a 1 to clear | 0x0 | When this bit is 1 falling edge mcap_mode is detected - plm should release mcap_mode configuration in SBI_CTRL.Interface. |
| MCAP_MODE_RE | 9 | wtcReadable, write a 1 to clear | 0x0 | When this bit is 1 rising edge mcap_mode is detected - plm should set mcap_mode configuration in SBI_CTRL.Interface. |
| JTAG_OVF_ERR | 8 | wtcReadable, write a 1 to clear | 0x0 | JTAG overflow error encountered. If CDC FIFO is full and JTAG data is valid, the JTAG overflow error is reported by jtag_ovf_err. |
| SMAP_OVF_ERR | 7 | wtcReadable, write a 1 to clear | 0x0 | SMAP overflow error encountered. If CDC FIFO is full and there is write to SMAP interface, the SMAP overflow error is reported by smap_ovf_err. |
| SS_OVF_ERR | 6 | wtcReadable, write a 1 to clear | 0x0 | Slave serial overflow error encountered. If CDC FIFO is full and there is write to slave serial interface, slave serial overflow error is reported by ss_ovf_err. |
| MCAP_OVF_ERR | 5 | wtcReadable, write a 1 to clear | 0x0 | MCAP overflow error encountered. If CDC FIFO is full and mcap_cs_b = 0 and mcap_rdwr_b = 0, MCAP overflow error is reported by mcap_ovf_err. |
| AXI_APB_ERR | 3 | wtcReadable, write a 1 to clear | 0x0 | PMC Main Switch AXI slave error. Asserts when awsize is not 4 bytes or burst type is WRAP during an AXI transaction. |
| DATA_RDY | 2 | wtcReadable, write a 1 to clear | 0x0 | Valid configuration data into SBI buffer which will raise an interrupt to the Micro Blaze. |
| SMAP_ABORT | 1 | wtcReadable, write a 1 to clear | 0x0 | A SelectMAP abort is triggered when RDWR_B toggles while CSI_B is asserted. This can happen during SelectMap configuration or readback sequence. (Requires SBI block reset and CCLK running to clear this status) |
| INV_APB | 0 | wtcReadable, write a 1 to clear | 0x0 | APB (register) access occurs to an unimplemented space, slave error. |