DMA_DST_CTRL2 (OSPI_QSPI) Register Description
| Register Name | DMA_DST_CTRL2 |
|---|---|
| Offset Address | 0x0000001824 |
| Absolute Address | 0x0004091824 () |
| Width | 32 |
| Type | mixedMixed types. See bit-field details. |
| Reset Value | 0x0000FFF8 |
| Description | Destination DMA Control Reg 2 |
DMA_DST_CTRL2 (OSPI_QSPI) Register Bit-Field Summary
| Field Name | Bits | Type | Reset Value | Description |
|---|---|---|---|---|
| Reserved | 31:29 | razRead as zero | 0x0 | Reserved |
| AWCACHE | 26:24 | rwNormal read/write | 0x0 | Sets the AWCACHE bits on the AXI Write channel as follows: Bit 0 - Sets the AXI AwCache[0] signal Bit 1 - Sets the AXI AwCache[2] signal Bit 2 - Sets the AXI AwCache[3] signal Note that AwCache[1] is always driven to 1 |
| Reserved | 23 | razRead as zero | 0x0 | Reserved |
| TIMEOUT_EN | 22 | rwNormal read/write | 0x0 | 0: The 2 Timeout counters are disabled 1: The 2 Timeout counters are enabled |
| TIMEOUT_PRE | 15:4 | rwNormal read/write | 0xFFF | Set the prescaler value for the timeout in clk (~2.5ns) cycles (Refer to TIMEOUT_VAL description). The TIMEOUT_PRE field is interpreted as follows: 12h000: Prescaler enables timer every cycle 12h001: Prescaler enables timer every 2 cycles etc 12hFFF: Prescaler enables timer every 4096 cycles |
| MAX_OUTS_CMDS | 3:0 | rwNormal read/write | 0x8 | Controls the maximumum number of outstanding AXI write commands issued. The field is interpreted as follows: 4h0: Up to 1 Outstanding Write command allowed 4h1: Up to 2 Outstanding Write commands allowed etc 4h8: Up to 9 Outstanding Write commands allowed 4h9 - 4hF: Invalid. Valid range is 4h0 to 4h8. |