Managing the Simulation Environment

IPsec_GW Reference Pipeline User Guide (UG1671)

Document ID
UG1671
Release Date
2024-02-15
Revision
1.1 English

Once the build process is complete, start the simulator on the built reference pipeline using the following command: 

./tools/dsc-sim-start.sh --p4_program ipsec_gw

At this point both the ASIC simulator and core application are running, and the two uplink interfaces (uplink0 and uplink1) are exposed to Linux® as tap interfaces (Eth1-1 and Eth1-2). Validate this by running show commands such as the following:

pdsctl show lif
pdsctl show port status

As a part of the simulator startup, the dp-app process is started, which reads the file /sw/nic/rudra/src/conf/ipsec_gw/config.json. This file contains instructions to create the flow with policy and route results, and to populate specific entries into the tables. To view the file, run the command:

cat /sw/nic/rudra/src/conf/ipsec_gw/config.json

If desired you can expose the uplink interfaces outside the container, so you can run traffic tools from outside to inject packets to the uplinks, To do so, run the following commands on the host of the container:

cd $TTOP/src/github.com/pensando/sw/nic/
DSC_INSTANCE=<ssdk-dev-container-name> ./rudra/test/tools/setup-uplink-interfaces.sh
Note: <ssdk-dev-container-name> can be obtained via docker ps.

To stop the simulator environment, execute the dsc-sim-stop.sh script. This kills the processes including the ASIC simulator and pds core application:

./tools/dsc-sim-stop.sh

To restart the simulation environment, execute the dsc-sim-restart.sh script. This restarts all the processes including the ASIC simulator and pds core application, which is useful in recovering from scenarios such as a process crashing:

./tools/dsc-sim-restart.sh --p4_program ipsec_gw